Here is my first wiring problem. The wiring harness for the stock Dana 44 has two molded connectors that both have 2 wires in them. The new Dana 60 has just two wires sticking out of it. Something has to give here.

stock axle wiring loom
How do I wire this?

I can assume that one of the connectors on the jeep wiring harness is used to energize the locker, but I'm not sure what the other connector does. My guess is that it provides feedback to the jeep about the engaged/disengaged state of the locker.

Dana 60 locker leads
These are the leads sticking out of the axle?

Here is what is sticking out of the Dana 60's. There is a plastic connector body included for those two pre-terminated leads along with the mating end that is pre-wired with several feet of wire leads. However, none of the provided wiring is a plug-in fit for the factory harness. It's provided for those who are installing the Dana 60's into a vehicle without any existing wiring. Some cutting and splicing will be required to mate the Dana 60's to the Jeep wiring.